MOBICEL Mercury User Manual

DCTS-900Digital Cell UnitUSER’S MANUAL

5INSTALLATION1. Site PlanningFor optimum operation, effective site planning is necessary. Once the cellunit is installed, no further maintenance is r

6Position the switches according to the following diagrams for the appropriateIDs :Note: Every cell unit is factory set as cell ID #1.4. Setting the

75. Installing the Cell UnitYou may choose from two (2) installation options:n locate the cell unit on a desk or tabletop, orn mount the cell unit on

83. Rotate the antenna on the cell unit to a vertical position.4. Plug the AC power cord adapter into a standard 120VAC wall outlet.Monitor the cell

95.2 Wall Mounting - Directly on the WallYou may mount the cell directly on the wall. You will want to ensure thefollowing:n The location where the c

10If the AC outlet and/or telephone jacks are located below the cell unit refer toSteps 4 and 5.4. Route the power cord and telephone cords through t

117. Plug the telephone line cords into the telephone wall jacks. ObserveL1/L2 and L3/L4 polarity. If the telephone line cords are reversed, thecel

126. Setting the System Security CodeAll handsets must be programmed for the same security code. Only onehandset needs to transmit the code to the ce

136.2 Air LinkThe system security code (SSC) should already be programmed for thehandset. Once the master cell unit is plugged in, you have approxima

14 MAINTENANCE1. Resetting the Cell UnitResetting the cell will return all programmed settings to default values.1. Position the four (4) switches on

MobiCel Systems, Inc. has made every effort to ensure the technical accuracyof this manual. Features and technical data are subject to change without

152. Resetting the HandsetResetting the handset will return all programmed settings to default values.1. Press .2. Dial .3. Pres

PRODUCT SPECIFICATIONSThe MobiCel DCTS-900 Digital Wireless Office Communications System canbe installed behind any PBX, or as a stand alone SOHO (sma

Mechanical: 2 each RJ-14C JackDip Switch ID SettingPower Jack 12VDCRF: 902-928 MHzDigital TDMADimensions: 217 mm long152 mm wide39 mm highWeight: 17.3

DCTS-900 SYSTEMINSTALLATION CHECKLIST1. Unpack the first cell unit and set the dip switches to Cell ID 1 setting.2. Power up Cell #1 and verify that

DCTS-900 SITE MAP

CELL UNIT WALL MOUNTINGTEMPLATE

PBD9400A

iWARNINGMobiCel Systems, Inc. doesn’t represent this unit to be waterproof. Toreduce the risk of fire, electrical shock, or damage to the unit, do no

iid. If the product does not operate normally when following theoperating instructions. Adjust only those controls that arecovered by the operating

iiiTABLE OF CONTENTSINTRODUCTION1. Becoming Familiar With Your Wireless Communication System ... 12. The Features ...

1INTRODUCTION1. Becoming Familiar With Your WirelessCommunication SystemThe DCTS-900 system consists of one (1) to seven (7) cell units and up tosixty

22. The FeaturesYour DCTS-900 system provides many features such as:Four (4) CO/PBX Line CapacityTone/Pulse Dialing ModesSpeed Dialing (10 Numbers)Las

33. What’s Included With Your Cell UnitCell Unit Power AdapterLine Cords Cell Unit User’s Manual Wall MountingScrews & Anchors

44. Other Optional Accessories4.1 Caller ID ServerThe Caller ID Server provides the DCTS 900 System with Caller IDcapability at all extensions. The s