14
MAINTENANCE
1. Resetting the Cell Unit
Resetting the cell will return all programmed settings to default values.
1. Position the four (4) switches on the back side of the cell unit as follows:
Switches 1, 2, and 3 are set to “off”. Switch 4 is set to “on”.
2. Unplug the cell unit power adapter to “reset” the cell.
3. Plug in the cell unit power adapter.
4. Observe the cell unit diagnostic LED. It should flash once every 2
seconds.
5. Refer to section 3 to set the correct cell ID.
Comments to this Manuals